Drop & Offset Mounts for Low Pulls, Rows & Floor-Level Cable Work

How do I get the VOLTRA I low enough for seated rows, floor pulls, and deep pulls?

The VOLTRA I is moved offset from the upright in order to achieve a drop. You move the VOLTRA I and the cable follows. Use that for rows, floor-level work, and range of motion. Pin size comes first. Geometry is cable height and offset after that.

Decide

Select the pin size before you pick a drop. Then choose how low the cable origin sits, and whether it sits beside the upright or crossmember.

Offset Drop

Single-pin offset. It puts a lower cable origin beside the upright or crossmember.

Offset Drop

Double Offset Drop

Offset drop for two VOLTRA I units.

Double Offset Drop

Evolver Deep Drop

A deep drop arm, about a 6-7/8 inch drop. It needs clearance under the pin height.

Evolver Deep Drop

Rogue T-Bar Row Offset Drop

1" single pin (not included). It is designed to fit the Rogue T-Bar Row stand and drop the VOLTRA I low.

Rogue T-Bar Row Offset Drop

Side Mount Bolt On Deep Drop

It is bolt-on, not pin-based. The drawing shows it on a Simple Upright as an example. It bolts to the side of the upright with four hex bolts and drops the VOLTRA I below the beam. Other bolt-on Mounts use their own bolt pattern.