Rogue T-Bar Row Offset Drop Mount for Beyond Power VOLTRA I - 1" Single Pin 3x3 Rack

Current production: Rogue mounts shipping from Voltra Mounts today are V2 (two 12 mm holes under the DIY Dock). Older V1 mounts have one hole. If you later order a Dual Voltra Plate, that version note helps us pack the right adapter.

Rogue T-Bar Row Offset Drop is a single-pin mount for the Beyond Power VOLTRA I. It is built for the Rogue T-Bar Row stand (3x3 with a 1" push pin, not included) and uniquely lowers the VOLTRA I so it sits just above the floor, with the cable below the top of the foot plates. The offset also moves the VOLTRA I rearward for better foot position and a deeper range of motion.

This listing is the Rogue T-Bar Row Offset Drop. It is a single-pin mount for 1" holes.

2:1 with a lifting eye

The mount has an M10 × 1.5 threaded hole for a lifting eye. With a lifting eye installed, this mount can be used with another mount to create a 2:1 doubling setup. The lifting eye is not included.

Lifting eye

If you want a lifting eye with this mount and dock setup, use the M10 Lifting Eye — Closed Ring (not included). The Hook w/Clip is too tall; when installed in the dock, it hits the side of the Beyond Power VOLTRA I.

• M10 Lifting Eye — Closed Ring

For two VOLTRA I units on this mount, see the Dual Voltra Plate.

Fit and options

• Made for the Rogue T-Bar Row stand; also fits other 1" pin 3x3 racks where a deep offset drop is desired
• Device: Beyond Power VOLTRA I
• Pin type: Single Pin — 1" push pin (not included)
• Mount orientation: rearward between the foot plates, or forward for landmine-style work with a bar
• DIY Dock: optional. When that option is selected, one Dock is included.

What’s included with every mount

• Chafe pad shims
• Allen wrench

Note: This is for the mount only. The Beyond Power VOLTRA I, Rogue stand, mag pin, lifting eye, and DIY Dock are not included unless the DIY Dock option is selected. The push pin (not included) does not ship with the mount.

Proudly made in the USA.