Evolver Deep Drop Mount
1" Hole / Included (2 Docks)
$190.00
Sale price
$190.00
Regular price
Skip to product information
Evolver Deep Drop Mount
$190.00
Sale price
$190.00
Regular price
Shipping calculated at checkout.
The Evolver Deep Drop Mount is a heavy-duty drop arm designed to extend your VOLTRA I mounting point lower on your rack or rig. Part of the Evolver mount product line, this deep drop gives you a full 6-7/8" of drop from the top side of the upright or crossmember to the bottom side of the drop arm.
Key Features & Specifications:
- Provides a generous 6-7/8" total drop for improved pulling angles and range of motion.
- Available in 5/8" or 1" rack hole sizes.
- Ideal for use with VOLTRA units on power racks, squat racks, and rigs.
- Most effective when pulling straight from the VOLTRA I.
Fitment Note: Please measure your planned installation location carefully before purchasing. You will need at least 7 inches of clear drop from the top of the upright or crossmember to the bottom of the drop arm for this mount to fit properly. Additionally, it is recommended you use a shorter length mag pin such as Titan Fitness or PRx which are no longer than 4.75". This is recommended since the VOLTRA I is offset a minimal distance from the crossmember and a shorter mag pin doesn't impact the side of the VOLTRA I when locked in the DIY Dock. Mount may be bolted to rack also.
Important Usage Guidelines:
- Approved pulling angle for the Drop Arm is perpendicular to the base plate or up to 10 degrees beyond perpendicular up to the maximum weight of the VOLTRA I.
- Doubler plates are not approved for installation on the Drop Arm but can be used on the top mounting position if desired.
- Maximum Approved Load for the Mount Drop Arm is equal to the maximum resistance weight of the Beyond Power VOLTRA I unit.
Product Contents: This listing is for the Evolver Deep Drop Mount only. Hardware is included for standard installation. VOLTRA units, doubler plates, push pins and other accessories are sold separately.
Built tough in the USA for serious lifters looking to optimize their VOLTRA I training setup.
Proudly made in the USA.
Specifications
| Length | 9.25 in |
|---|---|
| Height | 7.0 in |
| Width | 4.1875 in |
| Weight | 4.4625 lb |
| Weight with DIY Dock | 4.95 lb |
| Drop | 5.0 in |
| Offset | 3.0 in |
| Rack fit | 3x3 with 5/8" or 1" push pin (not included); up to two DIY Docks |
| Material | A36 steel, gloss black powder coat |
| Material thickness | 0.25 in |
| Included hardware | 6 × M4-0.7 × 10 mm flat-head socket cap screw 4 × M4-0.7 × 12 mm flat-head socket cap screw |
| Notes | Weight 4 lb 7.4 oz without dock; 4 lb 15.2 oz with DIY Dock (shown as 4.4625 lb / 4.95 lb). Can accommodate two DIY Docks — one on the top plate and one on the drop plate. Height 7 in; depth 9 1/4 in; width 4 3/16 in. Pin / hole center is 5 in from the bottom of the mount and 2 in from the top of the plate (7 − 5). Offset is from the side plate to the center of the DIY dock (3 in). Clearance from the side of the drop-leg plate to the side of the VOLTRA I when installed is 7/8 in. A36 steel, 0.250 in thick, gloss black powder coat. M10 × 1.5 threaded hole on the top plate. No carabiner hole. |