Travel Platform Doubler — 45 mm Hardware Kit (Replacement)

The Travel Platform Doubler — 45 mm Hardware Kit (Replacement) is the correct screw set for Voltra Mounts Travel Platform Doubler Plate installs.

Beyond Power original platform screws are typically 35 mm (~1.38 in) and are removed at install. Voltra Mounts uses these 45 mm (~1.77 in) screws so they fully engage.

If your kit included 35 mm screws by mistake, you can order this replacement kit on your own from this page — no call or email required for the screws.

This is a replacement hardware kit only. It is not the Travel Platform Doubler Plate. It is not a full mount.

What’s included

• 8× M4 × 0.7 × 45 mm countersunk set screws (right-hand thread)
• 1× 2.5 mm Allen wrench (hex key)

Install

• Torque: 35 in-lb / 4.0 Nm — do not exceed
• Use only with the Voltra Mounts Travel Platform Doubler Plate per the Help install steps

How to get it

• Add the kit to cart and check out as usual
• If you were included in the Voltra Mounts screw-length notice, check out with the same email used on your order so any notice pricing and shipping adjustments can apply automatically
• No need to contact Support to request the screws

For the consumer notice and length check, see the Travel Platform Doubler screw length notice.