Tall Upright
5/8" Hole / With DIY Dock
$90.00
Sale price
$90.00
Regular price
Skip to product information
Tall Upright
$90.00
Sale price
$90.00
Regular price
Shipping calculated at checkout.
Upright Mount (Bolt-On)
Add a permanent mounting solution to your Beyond Power VOLTRA I workout station with this Upright Mount. It bolts directly onto your rack’s upright or cross member using two bolts that are at least 1/2" longer than your existing hardware.
Spacing between bolt holes on rack is 6” and two bolts are required to install properly.
A chafe pad is included. It ships loose (not attached) and goes between the Mount and your rack to protect the rack finish.
The mount can be rotated 180 degrees and used in either direction. There are three possible DIY Dock mounting positions, but only two can be used at the same time: one Dock on the face of the plate, between the bolts, and one on the 90° foot, either on top or underneath. This gives you excellent flexibility in positioning your VOLTRA I exactly where you need it.
When a DIY Dock is on the face of the plate, the total hardware stack (bolt head plus any washer under it) must be under 1/2" (12.7 mm).
When purchased with a DIY Dock, one Dock is included.
Install guide: Bolt-On Mount Installation Guide
Note: Bolts are not included. A DIY Dock is included only when that option is selected.
Proudly made in the USA.
Specifications
| Length | 5.875 in |
|---|---|
| Height | 8.0 in |
| Width | 4.125 in |
| Weight | 2.6313 lb |
| Weight with DIY Dock | 3.1187 lb |
| Offset | 3.5 in |
| Mounting hole spacing | 6" center to center |
| Rack fit | Bolt-on 3x3; 1" or 5/8" holes; two holes 6" center to center |
| Material | A36 steel, gloss black powder coat |
| Material thickness | 0.25 in |
| Included hardware | None provided — customer supplies mounting hardware |
| Notes | Weight 2 lb 10.1 oz without dock; 3 lb 1.9 oz with DIY Dock (shown as 2.6313 lb / 3.1187 lb). Height 8 in; width 4 1/8 in at widest point; depth 5 7/8 in. Two mounting holes only, 6 in center to center. Center of bottom hole is 1 3/16 in from the bottom of the plate. Offset is from the face of the mount to the center of the DIY dock (3 1/2 in). Clearance from the mount to the side of the VOLTRA I when installed with the dock on the bottom is 1.5 in (1 1/2 in). A36 steel, 0.250 in thick, gloss black powder coat. No M10 lifting / doubling hole; no carabiner hole. |